Matt, Barney has a chapter on his site on this subject.
http://www.mgaguru.com/mgtech/engine/ch107.htm
I've always done most of this already and have to say it works well.
Larry Daniels
79 MGB LE
60 Bugeye
67 Austin A60 Pickup (Ute)
"You only need two tools: WD-40 and Duct Tape. If it
doesn't move and should, use the WD-40. If it
shouldn't move and does, use the duct tape."
----- Original Message -----
From: "Matthew Milkevitch" <mmilkevitch@yahoo.com>
To: <mgs@autox.team.net>
Sent: Sunday, November 04, 2007 9:09 AM
Subject: [Mgs] valve cover gasket
Fellow Listers:
Quick question: When installing a new valve cover gasket, should one put
some permatex sealant on one or both sides of the gasket (valve cover side
and cyl head side) or should the gasket be installed completely "dry"?
Thanks for the help....
Matt Milkevitch
'74 BGT
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|