> I am getting a vibration........
Richard,
If you're getting vibrations while at a standing stop, with the clutch depr
essed, that should eliminate any drive train issues. (i.e. wheel bearings,
u-joints, rear end, etc.)
I assume then that the frequency of vibration increases and decreases with
engine speed, again at a standing stop.
I would check to make sure that the fan and all of its blades are all fully
intact, and not cracked or missing. I would also check your fan belts to make
sure there are no chunks missing and are in good working order. You could run
the engine, for a short period of time ( a minute or so ) with the fan belt
removed. If the vibration is still there, then you have eliminated the fan,
water pump and alternator, i.e.anything driven by the belt as the source of
vibration.
Steve
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|