What Bill said.
If the block wasn't cleaned in a corrosive solution, the bearings will
usually be ok. At a first rebuild, I normally leave them alone.
Do a visual inspection to make sure they were not damaged when the cam
was removed.
It's not a job I would bother doing at home. Most cam bearings for the
car need to be sized after installation. Gone are the days when you
could get AE bearings which were pre-sized and usually didn't need
additional work.
Kelvin Dodd
> -----Original Message-----
> From: mgs-bounces+doddk=mossmotors.com@autox.team.net [mailto:mgs-
> bounces+doddk=mossmotors.com@autox.team.net] On Behalf Of Ron Fine
> Sent: Tuesday, September 25, 2007 8:56 AM
> To: mgs@autox.team.net
> Subject: [Mgs] Cam Bearings
>
> I purchased a new cam (stock) and gave the machine shop that is
machining
> my
> MGB engine a set of new cam bearings to install. Now the machinist is
> telling
> me I don't need new cam bearings. I just assumed that if I was
installing
> a
> new cam I should replace the bearings. Should I accept his advise or
find
> a
> new machine shop to install them? Do I need any special tools to
install
> them
> at home?
> Ron Fine
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|