Good job of improvising Dan.
PITA job. I've got to do some digging for part numbers. Rocket makes a
flywheel bolt for a Chrysler application that has a slightly taller head
making them less prone to rounding.
This is one of the areas where an air impact wrench makes all the
difference.
Kelvin Dodd
> -----Original Message-----
> From: mgs-bounces+doddk=mossmotors.com@autox.team.net [mailto:mgs-
> bounces+doddk=mossmotors.com@autox.team.net] On Behalf Of Dan DiBiase
> Sent: Tuesday, August 28, 2007 9:03 AM
> To: MG List
> Subject: [Mgs] Home-Built Flywheel Holder
>
> Here is what I ended up doing, after thinking on it for a bit.....
>
>
http://i24.photobucket.com/albums/c30/ddibiase/1976%20MGB%20Engine%20Wor
k/
> P8270013.jpg
>
>
http://i24.photobucket.com/albums/c30/ddibiase/1976%20MGB%20Engine%20Wor
k/
> P8270012.jpg
>
> I was able to get 2 of the bolts loosened immediately. The others are
a
> little tougher, and I am going to wait until I get my socket ground
down a
> bit so I don't round them off.
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|