My 1800cc motor runs flat at a specific spot when accelerating and I've run
out of ideas.. HELP!
I know this is an MG list, but I have a 1964 TVR Grantura that runs a MGB
1800cc motor and trans. So I am appealing to your collective wisdom on this
problem if I may. I got this car about a year ago after it sat for 6 years
and was not driven and was 100% stock, never seen a DPO. I have "Spiffed" it
up, replaced all brakes and so forth and the motor idles very smooth and
strong.
The problem is when accelerating it goes fine until ONE SPECIFIC SPOT where
it flattens out. Speed is maintained but no more acceleration, you can hear
and feel it wanting more of something, like a high speed miss. There is a
"Sweet spot" on the throttle where it will or will not do this, very
definitive.
Here is what I have done and can verify:
The timing is spot on
When I suck on the hose to the Dizzy I can see the plate advance
The shaft of the dizzy is not bent
There is good suction on the intake manifold
Changed spark plugs from new Champion to new Bosh (Told Champion can have
problems) at .025
Plugs are a nice colour, good mix of fuel/air
Carbs are rebuilt (new jets)
Needles are "MB" (standard)
Pots seem to rise and fall okay.. Not fully sure on this
Light oil in carb dash pots
New electric fuel pump
New points .015
New condenser (after a new one, thought defective but not)
New plug wires
New Lucas Sports Coil (Gold one) tried another coil same results
Gas tank cleaned, no obstruction in supply line
The only thing left I can think of is a Pertronix unit or different jet
needles. What really bugs me is the "Sweat spot" where it craps out on me
thoughts please?
Thanks, Pat
Victoria BC
Version: 7.5.476 / Virus Database: 269.11.10/943 - Release Date: 08/08/2007
5:38 PM
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|