I'd have said that as long as the keyways lined up on both pairs of gears
you will be fine. The position of the teeth is immaterial, they are only
used to pull the chain which turns the other gear. If the keyways were
lined up on one gear but not on the other, then you *would* have a cam
timing error on one set or the other. Quite why the two sets are different
is something else.
PaulH.
----- Original Message -----
> We set the old gears on the bench and put the new ones on top of them.
> Then
> we lined up the notches for the keyways and the timing marks on both sets
> of
> gears. When these were lined up, the teeth on both gears do not match the
> teeth on the old ones? Both are about a half tooth off.
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|