Mike:
We need to know the VIN number. Early 1500s had 3/8 x 20 BSF threads,
later ones had 3/8 x 24 UNF
Kelvin Dodd
> -----Original Message-----
> From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net]
On
> Behalf Of Mike Duvall
> Sent: Tuesday, June 12, 2007 10:21 AM
> To: mgs
> Subject: [Mgs] brake line fitting
>
> Can anyone tell me what the thread is on MGA brake lines? I lost the
> sensor at the 4 way connector near the engine. I got the sensor at a
> local NAPA but while getting it loose it I damaged the line that goes
> to the rear of the car. I took the fitting over to the local brake
> store and he sold me a line for $10. It is standard fitting he
> pulled from a small selection in front of the counter. He took the
> fitting and the line and checked them against a fitting and said
> they fit ok. He was concerned I didn't strip out my 4 way.
>
> I'm concerned it was a close fit but not the exact thread. I don't
> want to screw up my threads either....any advice is appreciated.
>
> Please respond to me directly as I get the digest not individual
> emails. thanks
>
> Mike
> _______________________________________________
> doddk@mossmotors.com
>
> Edit your replies
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|