I had to check the archives but there is this one:
http://www.thetoolwarehouse.net/shop/TA-61900.html
It looks like it was a little more than two years ago, on this list,
that Don Malling made a group purchase because this company had a
minimum purchase of $50. He ordered quite a few and parted them out to
the list at cost or maybe slightly above. I took one of them and have
used it once so far. It did work quite a bit better than my slightly
oversized pickle fork and was also non-destructive (I think I was just
doing a gaiter replacement).
David Councill
67 BGT
72 B
01 Land Rover Discovery 2 SE7
-----Original Message-----
From: owner-mgs@Autox.Team.Net [mailto:owner-mgs@Autox.Team.Net] On
Behalf Of Ed Woods
Sent: Tuesday, June 05, 2007 1:21 PM
To: Bob Howard; rolindsay@yahoo.com
Cc: peter@nosimport.com; mgs@autox.team.net
Subject: Re: [MGS] MGB tie rod end removal
O.K., I've used that type before, but have never found one small enough
for
an MGB tie rod end. Where can I find one?
If someone out there has one, what's the manufacturer's name?
Ed Woods
|