Sounds like an aftermarket/PO mod, depends on what glue and materials they
used.
Ohhh, the *bonnet*! I'd just rip the old one off and glue the new one back
on to the bits that are left, they are probably stuck pretty well and you
won't see them! If you can get contact adhesive solvent to allow you to
remove most of what remains then fair enough, but I wouldn't take a wire
brush to it or it'll need repainting afterwards.
PaulH.
----- Original Message -----
> .....I'm replacing the insulation on the underside of
> the hood in my 72 B. The question I have is, has anyone any experience
> removing the dried, glued on original installation pad?
|