| To: | "Gordie's Garage" <mg_garage@comcast.net>, |
|---|---|
| Subject: | Re: clutch to flywheel torque |
| From: | Barney Gaylord <barneymg@MGAguru.com> |
| Date: | Sat, 21 Jan 2006 09:18:07 -0600 |
At 05:18 AM 1/21/06, Gordie Bird wrote: >Reading my MGA shop manual wrt subject I find 2 possible >entries. One states "Clutch assembly to flywheel 25lb.ft." and a >few lines further down states "Clutch to flywheel bolts 35 to 40 lb.ft." >I'm confused. This sounds like the same bolts to me. Can anyone >enlighten me? It's a misprint. The second one with higher torque is for "Flywheel to crankshaft". Barney Gaylord 1958 MGA with an attitude http://MGAgutru.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Replacement of Brake Light Switch, Paul Hunt |
|---|---|
| Next by Date: | Clean up silicon brake fluid, Tom Gunderson |
| Previous by Thread: | Re: clutch to flywheel torque, Paul Hunt |
| Next by Thread: | Clean up silicon brake fluid, Tom Gunderson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |