MG Listers,
While changing the clutch I'm doing some preventative maintenance including
replacing the subject seals. I have the clutch out and have cleaned up
everything but the engine bay. What other parts should I replace as a normal
course?
Rear crank seal questions: How difficult is it to remove the flywheel?
Should I remove the endplate? Is there a gasket on the endplate?
Front gear box oil seal questions: Are special tools required? How
difficult is it to fit the shims?
The Bentley and Haynes service manuals aren't too explicit. Does anyone
have specific guidance to replace the seals?
Thanks in advance.
Steve Hughes
Gainesville, FL
|