I used an EeziBleed to reverse-fill my clutch so it didn't need bleeding at
all. Connect it to the *slave* nipple with *very* low pressure, only about
5 psi is needed as it was only pushed on and I didn't want it blowing off,
or fountaining out the top of the master. When I've used it for brakes i.e.
screwed onto the master I used just a few psi less than the maximum
recommended and had no problems. Other than not exceeding the maximum there
is no 'proper' pressure.
----- Original Message -----
> I have a new Gunson's Eezi-Bleed, and it says not
> to exceed 20 psi pressure supply when using it. But I think I remember
> somebody recommending a lower pressure for our MGs...
|