In a message dated 15/07/2005 9:50:26 AM Pacific Standard Time,
owner-mgs-digest@autox.team.net writes:
Take a look at illustration Ha.1 in the workshop manual. That's the
bizzare stretcher rig. The Salisbury axles have deep holes in the
casting, into which the bolt&nut you see in the middle of the beams fit.
Looks like a tool left over from the Inquisition, doesn't it?
____________________________________
Looks like something from a gynecologist's tool bag......;-)
Best NOT to use a case spreader. Too many diff bearings have been assembled
with excessive preload and wear out prematurely as a result.
Lever them out with a wrench and screwdriver, and tap them back in - if you
even need to, as most have sufficient clearance.
Bill
|