Max,
Take a look at illustration Ha.1 in the workshop manual. That's the
bizzare stretcher rig. The Salisbury axles have deep holes in the
casting, into which the bolt&nut you see in the middle of the beams fit.
Looks like a tool left over from the Inquisition, doesn't it?
Bob
On Thu, 14 Jul 2005 15:05:11 -0700 Max Heim <mvheim@studiolimage.com>
writes:
> I've never done this job (I have a banjo), but I'm gathering that the
> lack of 1/100th of an inch of space requires using a spreader tool?
Heck,
> I'd get out the grinder, too, in that situation. How did they ever let
that
> out of engineering? Good grief...
>
>
> --
>
> Max Heim
> '66 MGB GHN3L76149
> If you're near Mountain View, CA,
> it's the primer red one with chrome wires
|