Pull as a unit is the way I went. It was much easier to get at the oil seals
and re-attach the trans.
----- Original Message -----
From: <AGreenberg@aol.com>
To: <mgs@autox.team.net>
Sent: Sunday, June 05, 2005 6:29 PM
Subject: Best way to pull eng+xmission
>I have the unpleasant job of replacing my B's transmission. My son
>actually
> thought it had power and drove it a little to aggresively over the last
> few
> months and finally did in an already sick tranny.
>
> I have an other one and I'm planning on doing some odds and ends , oil
> seals,
> pump, clutch of course, any thing else?
>
> My question is. Should I pull the engine and the transmission
> separately?
> Or should I pull it them out as a unit?
>
>
>
> Best Regards,
>
> Alex
>
> Alex Greenberg
> Member CT MG club
>
> 1976 MGB - Fair weather daily driver ( Junior ) GHN5UC402027G
> 1993 Subaru Legacy LSi - ridiculously reliable great little car
> 1974 Ducati 750 GT - exquisitely beautiful motorcycle
|