Use a plain nut first to seat the taper, then remove and replace with nyloc
nut.
Ian F
----- Original Message -----
From: "Mike L" <renoman@sympatico.ca>
To: "Randy Widman" <riwidman@buckeye-express.com>; <mgs@autox.team.net>
Sent: Friday, May 06, 2005 1:47 AM
Subject: Re: Tie Rod Tightening
> Clamp the ball joint or otherwise force the taper fit into the steering
arm.
> (Or use a castellated nut and drill a hole for a cotter pin).
>
> Mike
> >
> > How does one go about tightening up the lower nut on the tie rods? It
just
> > keeps spinning when I try to tighten. TIA
> >
> > Randy Widman
|