OK, so head is off the B (73) for a valve job. In cleaning up the carbon
and stuff, it appears that my pistons have about 1/16" play side to side.
Rings? Compression test dry before pulling everything apart showed around
125# +- 4# on all pistons. I believe #4 was the lowest with a 121. Car
seemed to run peachy before, so it wasn't too bad (yet).
Since I believe it is the rings, I am going to start planning on that...
Can they be done with the motor in place, or does the motor *HAVE* to come
out?
Have a fantastic week!
TJ
|