Okay,
So I was a little giddy and went ahead and purchased the "Courtesy
Lights" kit from VB. I realize after seeing it that I paid way too
much for this. So, I'm installing it into a '66B. I've drilled a hole
for the switch in the door jamb. But it seems I've drilled into one
side of a 'box' that is about 5 inches deep. Of course the kit was a
generic type with no instructions. So, now I've got a problem with
attaching a nut on the other side of the switch to hold it in place. I
think I could "dremel" an access hole into the footwell that would not
only accommodate the wiring but allow access for a wrench to tighten
the nut. Or I could try drilling an even larger hole in the far side
of the box so I could use a ratchet (although this seems like the hard
way).
Has anyone else tried to install one of these kits in a Mark I MGB?
Doug
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|