I have wires but am pretty sure they are pressed into the drum from the rear
side, similar to US cars, and probably have a spline and head to prevent
them from spinning and pulling out when tightening the lugnuts.
Mike
'79B
----- Original Message -----
From: "S. Allen" <sallen3663@gmail.com>
To: <mgs@Autox.Team.Net>
Sent: Monday, October 18, 2004 4:34 PM
Subject: Stud Question
> Hi,
>
> I snapped off one of the wheel studs on the rear of my 74 1/2 today,
> (Rostyle rims, not wire) and I was wondering how hard they are to
> replace as the manual and expoded drawings aren't too clear.
>
> Can you just pop them out after removing the brake drum or do you need
> to remove the half shaft to get at them?
>
> I'm hoping it's the former rather than the latter...
>
> Any help appreciated,
>
> Scott Allen
>
> 74 1/2 BGT
> 52 TD
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|