Did you remove the folding top from the 79B?
on 10/17/04 7:30 PM, MonteMorris at mmorris@nemr.net wrote:
> I just finished putting new windows and seals all round in a factory hard
> top that came with our 67B. This hardtop was purchased with the 67 and I
> drove it back to Missouri from Seattle. On the way back from Seattle, the
> hardtop leaked a little and lacked the side locating brackets, but
> everything else seemed to be fine. I fitted new parts to it so I could put
> it on the 79B for the Missouri winters. It does not fit the 79. The windows
> have at least a half inch gap at the top before they would touch the seals.
> I turned the header seal around and still had the same problem. I even
> pulled the new header seal clear off and clamped the hardtop to the
> windshield, and it still has a huge gap at the window tops.
> Were the factory hardtops designed to fit the early B's but not the rubber
> bumpers? I didn't think there was any difference between the bodies of the
> two cars.
> Puzzled,
> Monte
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|