There *is* rubber in the elbow which is why I didn't want to use heat. In
the end I hacksawed through the A-arm in such a way that I could get most of
the way through without damaging the drop-link pin, then chiselled the cut
open before it freed the pin. Reassemble with copper grease!
PaulH.
----- Original Message -----
From: "Jason Spaeth" <jasonspaeth@hotmail.com>
To: <mgs@autox.team.net>
Sent: Saturday, July 17, 2004 1:32 AM
Subject: sway bar links
> I am still working on the front end disassembly. I noticed that both sway
> bar link studs are seized on the wishbone arms. Can I heat these up (in
> order to remove them) or will I damage the link? I am assuming that there
> is a rubber bushing in the elbow?
|