A couple more quick questions:
I have disassembled my distributor and cleaned it with solvent. It is a 25D
(I believe is what was stamped on it) with an Igniter Electronic Ignition
apparently installed by a PO. What type of oil/grease do I use on the
bearings and on the weights? Also, the vacuum advance moves slightly but
only when a lot of vacuum is applied. How easily should this move and how
much movement is enough? Perhaps I am due for a replacement.
Again, thank you.
Jason Spaeth
Early 74 B
North Branch, Mn
_________________________________________________________________
Is your PC infected? Get a FREE online computer virus scan from McAfee.
Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
|