The email addy I have for Kelvin is apparently no longer good, but, I just
received one of these as a replacement for a 3 main 1800 and find that the
pipe that actually goes into the block is too big in diameter to go into the
block. Pulled the same part from my 1622 A motor and find that there is @
.0040 difference in the diameter of the pipes. The part from the A fits
fine in the B block. Since there are no different part numbers/years listed
in Moss MGB catalog (same part # in MGA catalog too), I'm wondering if there
may be an issue with these parts.
My supplier is Jeff Zorn and I have already alerted him.
TIA.
Safety Fast!
Gordie Bird
'62 MGA
'67 MGBGT
[demime 0.99d.1 removed an attachment of type application/ms-tnef which had a
name of winmail.dat]
|