I'm a little confused by the Haynes manual's instructions on bleeding
the brakes on my 79 B. The main set of instructions say to start
with the wheel farthest from the master cylinder and work back to the
closest. But in the section about those cars equipped with the brake
pressure switch in the master cylinder (as mine is), it says to start
with the wheel closest to the master cylinder. Which one is correct?
Also, I've found that if I loosen the pressure switch 3.5 turns as
advised, I end up with a lot of fluid leaking from there while doing
the bleeding process. Is this normal?
--
Keith Gernert
79 MGB
--
|