Could it be that your buckets are installed upside down?
schooler wrote:
> Clearly you have purchased a set of Australian bulbs...
>
> Bill
>
> ----- Original Message -----
> From: "Mark Lennan" <mlennan@crankyrobots.com>
> To: <mgs@autox.team.net>
> Sent: Wednesday, November 19, 2003 11:09 AM
> Subject: Headlight trim rings
>
>
>
>>A quick question:
>>
>>Are the two rivets on the headlight trim ring (that hold the alignment
>>clip) supposed to be on the top of the ring or the bottom?
>>
>>I have reason to believe that (somehow...) the headlights housings are
>>installed improperly. My rivets are on the top of the rings when
>>installed.
>>
>>I recently bought some H4 units and after installing (lining up the
>>tabs on the headlight with the grooves of the housing) I found that my
>>low beams pointed up and my hi-beams pointed down...
>>
>>It appears that everything can only install one way but something is
>>amiss. A response from the MGB Experience BBS stated that the rivets
>>point down, but I cannot install with the rivets down because the large
>>holes in the headlight well (that accept the adjustment screw sticking
>>out, are only on the top, left and right side of the headlight hole.
>>
>>Figured I'd start with how it's supposed to look. Rivets up or down or
>>left or right?
>>
>>Thanks, all!
>>
>>Mark Lennan
>>79B
--
______
Paul T. Root <proot@iaces.com> / _ \
600 Stinson Blvd N.E., Fl 1S / /|| \\
Minneapolis, MN 55413 ||\/ || _ |
PAGER: +1 (877) 693-7155 || || ||
WORK: +1 (612) 664-3385 \ ||__//
\______/
|