The seat base cover should have flaps on all four sides. These are cut and
wrapped around the frame tubes (glue applied first) and held in place with
spring clips. The Porter Guide has a comprehensive section on seat
recovering.
PaulH.
----- Original Message -----
From: "Peter C." <nosimport@mailbag.com>
To: <mgs@autox.team.net>
Sent: Tuesday, September 16, 2003 3:54 PM
Subject: 67 B seat upholstery
> How does the seat bottom cover get attached at the rear of the seat? How
is
> provision made for the seat back support bolt pads? Does one cut the cover
> around them? What does the cover then clip to?
|