Never torque studs into the block. Make sure the threads are clean then
just bottom them, using two nuts if necessary. Torqueing the studs in to
the block can crack it. Torqueing the head nuts on is a different matter,
of course.
----- Original Message -----
From: "Randy Trautman" <trautman@nwlink.com>
To: "Mgs" <mgs@autox.team.net>
Sent: Wednesday, July 02, 2003 1:22 AM
Subject: Cylinder Head Studs
> What is the correct method to install and torque new cylinder head studs
> on a 5 main MGB?
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|