I replied directly to Rocky but failed to reply to the list, here is the
issue.
My 7/16" box end fits, but the open end is too tight. So I decided to
replace the nut. It seems neither a fine thread, or course thread nut
will fit the bolt.
The bolt appears to be the stock bolt (square head).
Larry Hoy
-----Original Message-----
From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net] On
Behalf Of Max Heim
Sent: Saturday, April 19, 2003 3:23 PM
To: MG List
Subject: Re: Distributor clamp nut and bolt
I would assume it is SAE -- I know I always use SAE tools on mine. But
some
PO could have replaced yours (or mine, I suppose).
Max Heim
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|