It's all a matter of cables reaching. I don't think there would be
a problem. The speedo cable should be long enough. Though it might be
more difficult to pull the speedo out of the dash. The tach's wires
are in the loom and probably only long enough for where it is. You'd
probably have to put on extensions. Simple blade connectors. If I
were to do it, I'd put 3-4 in extensions on, that way, it's just a
matter of taking off the extensions to put it back the way it was.
Paul.
Marc wrote:
> Is it possible to (easily) swap the positions of the tach & speedo in a RBB?
> Haven't pulled anything apart to look, but I sure would be happier to have
> my speedo on the left...
>
>
> --
> -----------------------------------------------------------
> Marc Siegel, Charm Net LLC eMail: smarc@abs.net
> Baltimore, MD http://www.abs.net voice: 410/361-8160
--
Paul T. Root E/Mail: proot@iaces.com
600 Stinson Blvd N.E., Fl 1S PAG: +1 (877) 693-7155
Minneapolis, MN 55413 WRK: +1 (612) 664-3385
FAX: +1 (612) 664-4779
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|