I'm in the middle of rebuilding rear brake cylinders (on the 67B) and have
a quick question.
The old inner seals on the piston are different than the ones in the rebuild
kit. The old ones look like they are the same diameter on both ends, but the
new ones have a smaller diameter on one end than the other (cone shaped).
One side is also solid around the circumference and the other side is split
(looks like a groove all the way around it). Which side of the cone-shaped
seal goes inwards? I hope this makes sense.
Thanks,
Monte
79B, Carmine
67B, BRG
74 1/2 Rust, parts car
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|