The jet would fall out the bottom if it were that low!
I don't think the feed tube would even let it go that low.
starting spec is closer to 0.060" below the bridge. (12 flats)
Paul Tegler
ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
> From: "Charles & Peggy Robinson" <ccrobins@ktc.com>
> To: "Larry Colen" <lrcar@red4est.com>
> Cc: <mgs@autox.team.net>
> Sent: Wednesday, February 19, 2003 12:08 PM
> Subject: Re: Tuning goals
>
>
> > Er, the needle acts to obstruct fuel flow through the jet, so when you
> > thin the needle, you richen the mixture. Also 1.35" is a long way below
> > the bridge. Is that a typo?
> >
> > Cheers,
> >
> > CR
> >
> > Larry Colen wrote:
> >
> > > I've also noticed that the jet is about 1.35" below "the bridge"
> > > to get this mixture, so I may actually want to make my needle thinner,
> > > and less tapered at the top so that the mixture stays leaner at low
> > > loads.
> > >
> > >
> > > Larry
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|