I've finally gotten around to starting a HIF carb rebuild to install on the
79 in place of the ZS.
I'm reassembling now and notice that I'm missing a little copper washer that
should be between the needle seat and the carb body. Evidently it is not
available; the SU rebuild video says to use your old one. How much
difference will this make to not have it. I would imagine it will slightly
change the mixture? Can I compensate by setting the float a little higher?
If so, about how much since I have no washer to measure.
Thanks,
Monte
79B, Carmine
67B, BRG
74 1/2 Rust, parts car
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|