Try heating up the metal part of the badge housing with a hair dryer
or heat gun on low, this should cause the adhesive to soften and
release to the point where you can pop it out with a small screwdriver
or penknife.
***********
On my 73 the housing is screwed to the grill shell but the screw heads
are
covered by the badge which is stuck in place. I'm told that it is
possible
to push the badge off the housing from the rear, which reveals the
screw
heads.
----- Original Message -----
From: "Martin C. Galan" <batangelias@yahoo.com>
To: <mgs@autox.team.net>
Sent: Monday, February 03, 2003 2:59 PM
Subject: Re: MGB Badge&Housing
> Im about to disassemble a 1965 MGB housing and badge from the
grille
assembly. I would like to know if there are any locks, screws or other
fastening devices that I have to look out for?
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|