mgs
[Top] [All Lists]

Re: Good News/Bad News: some answers, some questions

To: "MG Digest" <mgs@autox.team.net>
Subject: Re: Good News/Bad News: some answers, some questions
From: "N" <twobees@sprynet.com>
Date: Fri, 31 Jan 2003 22:16:02 -0500
Earlier in this thread, someone was discussing "sanding" the head & block to
get rid of machining marks.  It reminds me that on one of my heads & glued
two pieces of wet/dry paper to an old formica-topped counter top & pushed &
pulled that head back & forth hundreds of times.  End result - a very smooth
surface that even cut down some very slight imperfections in the machining.
AND, most important - no blown gasket or leaks.

In addition, only use a Fel-Pro #21183 C gasket & spray both sides with
copper or aluminum gasket "stuff."

Norm Sippel
'66 MGB

///  or try http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>