Ok, so I am a boob.
I am taking my MGA out of mothballs because I just sold my MGB and I now plan
on finishing my MGA. I am at the half way stage, chassis ready for body,
engine and trans rebuilt, etc.
Question: I changed over to the timing chain cover that has the Press-in type
rubber seal that seals around the crankshaft pulley.
I consulted the haynes manual, and it states that a later oil thrower should
not be used in a early timing cover, and vice versa.
My only problem is: I don't remember which oil thrower I have!
The one I have, as best I can describe it, is a convex on one side large
washer that fits over the end of the crankshaft and has a cutout for the
keyway.It is to be installed concave OUT......Can I use this with my later
type timing chain cover, and if not, what does the later type oil thrower look
like so I can get it?
cheers
Kevin.
back to one MG...the 62A
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|