I'm in the upstate NY (cold).
If I have the air compressor in an unheated garage will there be a
problem with starting it in cold temperatures: 20F? Should I leave it
depressurized so starting it in cold weather will be easier?
I think I'm going to get a 80 gal single stage Ingersole Rand 13CFM or
so @ 90PSI (I think...)
I understand that a dual stage will pressurize faster, but if I'm happy
with the CFM at single stage, why would I care about dual stage? Seems
the CFM is criteria not dual stage vs single stage. I believe that I
can use a smaller motor at a given CFM with dual stage than with single
stage, but if I'm getting the CFM I need, at the cost I want to pay,
then why do I care about motor size? (Assumes I don't care about the
cost of running the motor). This would be for occasional use -- home
use. Yes/No???
Thanks,
Don Malling
Bullwinkle wrote:
>
> So I'm setting up my new air compressor. A fairly small
> 2HP oiler. And I got a couple of questions.
>
> <<<snip>>>
> 1) Can I use it, or if not, where do I find non-detergent
> oil?
> <<<snip>>>
> I bought compressor oil at Menards. Use 30 wt.
> non-detergent. You can find it a hardware stores that cater
> to the farming establishement.
>
> <<<snip>>>
> 2) Then males on all the tools. Is that ok?
> <<<snip>>>
> That's the usual proceedure as the male connect is cheaper
> and you need one for every tool.
>
> <<<snip>>>
> I found, when I got home, that the hose is 1/4 male thread
> at
> both ends, so I had to go back and get a coupler yesterday,
> but I
> haven't had a chance to hook it up yet.
> <<<snip>>>
> The spigot end can be found with male or female threads. I
> use the Lincoln style connectors. These lock open when
> disconnected. Thus the locking ring doesn't have to be
> pulled back to hook on a tool.
>
> <<<snip>>>
> 3) Any worry about leaks? I have a roll of plumbers teflon
> tape.
> Should I use it, is it overkill, or will it do no good?
> <<<snip>>>
> Use it or PTF pipe thread compound. Just make sure that
> none of it is too close to the end and gets into the hose or
> connection to plug up tools.
>
> <<<Snip>>>
> 4) It should be ok to leave it pressurized all the time in
> the garage, right? Leave it on or turn it off?
> <<<snip>>>
> You can probably leave the tank pressurized, but shut off
> the power. That's what I do. You don't want the compressor
> starting up when you not around to watch it. In cold
> climates or garages you don't want the compressor starting
> up. Sometimes the compressor is so stiff that the motor
> cannot turn it over. This can cause belts to slip, burn up,
> or start fires.
>
> Blake
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|