Actually, I would say that the distributor was one device that wouldn't
necessarily be damaged by submersion. Just take it apart, clean and lube it.
If the mechanical advance bits move freely, the plate turns smoothly, and
there's not too much wobble in the shaft, then just replace the consumables
and you're good to go.
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
on 12/3/02 8:28 PM, BarrMark262@aol.com at BarrMark262@aol.com wrote:
> Hi List: Since I am quite certain my LBC 74 B was under water at one time, I
> want to have the dist. rebuilt or buy a new one.
> What can anyone tell me about this decision, and who is a good rebuild shop.
> I know a new one is about $250.00, but I don't know about rebuild costs
> and/or quality of work.
> Any help is greatly appreciated.
>
> Dennis Barr
> About ready to start reinstalling goodies, (car due back from painter)
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|