Re: Head replacement - cleaning the block

[Bullwinkle <yd3@nvc.net>]

Steve:

I use a stiff, not flexable, 1 1/2 inch putty knife gound to
a sharp edge to scape off gasket residue.  If you've got air
and a die grinder, there's also a neat little wheel that
uses Scotch Bright pads to clean up the surface.  This wheel
might work in a high speed 1/4 inch drill too.

Blake

///  or try http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive