I found that I needed several sizes. I'm fairly certain I needed 3/8 and
7/16, and perhaps another, larger size for the old fittings. I have those
Flare Nut wrenches, but I found that I could get real good torque on the
fitting with a regular Craftsman, although I did use them for the final
snug-down.
Jay Donoghue
72 B-GT
66 Mustang
In a message dated 9/9/02 3:16:12 PM, skye@ffwd.cx writes:
<< What is the correct size for the brake lines?
I don't need a whole set...
Skye
Word on the street is Ajhsys@aol.com said:
> Buy a Flare Nut wrench in the correct size. A flare nut wrench is an open
> end wrench with 5 flats instead of 4. You need 5 flats to keep from
damaging
> the fittings. >>
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|