Thanks to all of you for your helpful suggestions on replacing my BMC in a
70B.
I took the afternoon off work yesterday and using those suggestions, was
able to get the BMC replaced without disconnecting the line from the clutch
master cylinder. By removing the fasteners from the supporting bracket I was
able to get enough clearance to remove and replace the Brake master
cylinder. Tonight I'll finish bleeding the rear brake lines and then I'm
good to go again. Hopefully I can get to meet some of you in person at the
British Car Show on Sept 8th at Tipton Pa.
Thanks again to all the knowledgeable listers out there.
+++++++++++++++++++++++++++++++
Gerald L. Otterbein / Mgr. Software Services
The Young Industries, Inc.
16 Painter St.
Muncy Pa. 17756
Phone: 570.546.1820
Fax: 570.546.1920
[mailto:GLOtterbein@Younginds.com]
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|