I've replaced both clutch and brake m/cs in different cars (all
single-circuit remote servo though) with the mounting bracket in place.
There is an access plug in the firewall you have to remove, and it is a bit
of a fiddle, but it can be done.
----- Original Message -----
From: "Otterbein, Gerald L." <GLOtterbein@YoungInds.com>
To: <mgs@autox.team.net>
Sent: Tuesday, August 20, 2002 11:40 AM
Subject: Brake Master Cylinder
> I have a replacement brake master cylinder for my 70 B, and I am preparing
> to install it. From all appearances in order to remove the old one, I'll
> have to remove the entire mounting braket including the clutch master
> cylinder.
> Am I correct ? Any other comments or suggestions would be greatly
> appreciated
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|