On the face of it that sounds correct to me. An ohmeter will show
continuity if its two probes are touched together. So it you touch one to
ground and one to a wire it will show any continuity between that wire and
ground. Wasn't that what you were looking for?
----- Original Message -----
From: "MonteMorris" <mmorris@nemr.net>
To: "Barney Gaylord" <barneymg@ntsource.com>; "MG list" <mgs@autox.team.net>
Sent: Thursday, June 20, 2002 4:15 PM
Subject: Re: blowing fuses
> I was checking using the ohm meter and touching the black lead to ground
> and the red lead to the end (one end) of the wire at the fuse box end. So
I
> assume I wasn't checking for anything besides current but using the
ohmmeter
> scale?
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|