That sounds like a great idea! When I was doing the harness on my Sprite,
I always thought it would be nice to have a list by component that listed
what wire went there.
Something like below
Generator
- Brown/Yellow to "D" terminal
- Brown/Green to "F" terminal
Control Box
- Black to "B" terminal
- Brown/Green to "F" terminal
- Brown/Yellow to "WL" terminal
- Brown/Yellow to "D" terminal
- Black to "E" terminal
ect...
That would at least give a guide for reference, and easier than reading the
wiring harness for installing
Patton
At 12:02 PM 5/24/2002, Carl French wrote:
>I have a new wiring harness for my 67 Mk1 MGB. I am thinking that snipping
>each wire off about three to four inches from each connection will give me
>a guide to run the new wires. I would also keep the wire clips mounted
>with some wire to show the location. Any thoughts and tips?
>
>Carl French
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|