> The mixture adjustment on an HIF is as follows: screwing the adjusting screw
> inwards (i.e. clockwise) richens the mixture, counter-clockwise leans it.
>
> The float level should be measured across the center of the float. Doing
> this before the jet is installed makes accurate measurement easier.
This is what the SU manual says for HIF4. Recheck your video and I believe
you said the opposite in it. The video was still great help and confidence
builder.
Just took B for spin and running great. Had to put old float valve and seat
back in cause the new one wasn't seating. Not good when you have to put old
parts back in in place of new ones during rebuild when you paid dearly for
new parts.
Will drive to work in am for first time in month. Will be worth the wait I
hope. If not there is always AAA.
RobMGB
74B
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|