Greetings All,
I need to install a lap belt on the drivers side of my newly acquired '72
Midget. I would like some guidance on where to locate the holes to anchor it,
please.
This is planned to be a temporary measure. The in-frame anchoring for the
shoulder harness has rusted out and was filled and painted by the PO. So far,
the best solution for installing the reel appears to be welding a plate
w/tapped fitting to the floor or frame. Any advice or insight on dealing this
is most welcome.
Please reply to magicsue@earthlink.net as I will be working my little darlin'
all day at another location and can access a computer using that address to
check mail.
Thanks
Dale
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|