Barrie,
As I recall, the upper switch location on the right side was filled with a
blanking plate. Personally, I used it as the location for my manual choke. I
think the wipers were on a stalk. The light switch itself is on the dash with a
stalk used for high/low beam control.
Bud Krueger
Barrie Robinson wrote:
> Folks at world,
>
> Just trying to get new replacement dash cover stuck onto the steel base.
>
> Question 1 - Are the MGB 77-80 dash switches smaller that the previous
> dashes ? I measure hole in steel at 22mm by 30mm and ones I have been given
> are bigger than that
>
> Question 2 - There are four holes for switches are they hazard, heater,
> wiper and lights ? But then light switch is on stalk yes?
>
> By the way aligning the cover seems a bit of a sod as the moulding is not
> A1 accurate.
>
> Regards
> Barrie
>
> Barrie Robinson - barrier@bconnex.net
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|