Barrie,
Grab the screw and go to the local hardware store. Just match it up,
if you can lay the screw on top of another and the threads, which now look
like teeth, fit right into each other... viola! you've got a match. I did
this for some of the parts on the carbs to switch to stainless. The screws
to hold down the float bowl cover and the piston housing are the same and
are #10-24, 1/2" length is just fine. There are some others, I can't
remember them off hand.
Cheers!
Jim Laukaitis
'67 BGT
email: jim5@us.ibm.com
In the silence I hear my son crying.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|