Oh, didn't realize that. I bow to your superior knowledge (should have known
better... <g>)
on 3/28/02 2:55 PM, British Sportscar Center at Lawrie@britcars.com wrote:
> Very true - for HS carbs. I've never seen an HIF with a float that doesn't
> have an adjustment tang, though, and I must have rebult literally hundreds
> of pairs of these SUs over the last 27 years.
>
> Lawrie
> British Sportscar Center
>
> ----- Original Message -----
> From: "Max Heim" <mvheim@attbi.com>
> To: "MG List" <mgs@autox.team.net>
> Sent: Thursday, March 28, 2002 2:10 PM
> Subject: Re: Float Level Checking
>
>
>> I thought I should add that if you DON'T have metal tangs on the floats
>> (which can happen when the floats have been replaced by a PO), you can
> still
>> adjust the height by adding or subtracting washers under the base of the
>> needle valve.
>
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|