At 9:25 PM -0700 1/28/2002, swillis@premiernet.net wrote:
> > Does anyone know how these belts are to mounted. I have no instructions.
>> They are the lap type with big washers and bolts. Is it suffecient to
>mount
>> in the floorboards?
>> I can type with two hands today.
>> Thanks,
> > Scott
Scott:
You may already have an answer to your inquiry but the digest version
was not clear to me so I will respond. Do NOT mount the seat belts to
the floor boards! They mount outboard to a welded bracket on the side
of the frame and inboard to the transmission tunnel. If you need the
brackets you can get them from Todd Clarke at CSR (215-348-0595). He
will also provide you with a diagram showing the exact placements of
the mounting points.
I have installed the above on my MGA. One note of caution: because I
have long legs, when I restored my A I moved the seat bolts on my new
floorboard back about 1". My seat back now rubs against the outboard
mounting bracket. I should have mounted it back a compensating one
inch. If your set mounts have not been altered, the correct "factory"
mounting position will suffice.
--
Hal Roeth
Editor/Publisher, MGA! Magazine
2 County Route 2
Berne, NY 12023
518-797-3075
Visit our Web site at http://www.namgar.com
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|