Ok I have finally gotten everything hooked up and I think the clutch may be
actually in right this time. It is moving a half inch or so while pressing
the clutch petal to the floor:) I tried to turn the engine over last night
and it turned over once and then dies. I was unable to get it to turn over
again?!? Is there a way to set the timing without the engine running or a
trick to get it started so that I can set the timing with the timing gun.. I
believe that this is more than likely the problem.
Wesley Ryan
Project Engineer
GI Plastek
Phone: 937-645-4018
Fax: 937-642-5326
Cell: 937-243-0909
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|